FORESTER U.S.A. (E)
5
Audio
5-13
– CONTINUED –
J Display mode
You can select either the time display mode or function display mode by
pressing the “DISP/CLK” button when the ignition switch is either “ACC”
or “ON” position.
B Time display mode
When the time display mode is selected, the time display takes prior-
ity of the function display. The time is shown on the display whenever
the ignition switch is “ACC” or “ON” position.
When the radio is turned on or the station is changed during the time
display mode, the time display is replaced by the frequency display.
However, after the frequency has been displayed for five seconds, it
is replaced by the time display again.
B Function display mode
When the function display mode is selected, the time is not shown on
the display. The display indicates the current function only.
When the radio is turned off during the function display mode, the
back-up light on the display goes out.
J Setting the time
1. Turn the ignition switch to “ACC” or “ON”.
2. To adjust hour: Press the “DISP” button and the “TUNING” button
indicated with “
∨” together to advance the hours in one-hour increments.
Keeping the buttons pressed advances the hours quickly.
3. To adjust minute: Press the ”DISP” button and the “TUNING” button
indicated “
∧” together to advance the minutes in one-minute increments.
Keeping the buttons pressed advances the minutes quickly.
NOTE
If the connection between the radio and battery is broken for any
reason such as vehicle maintenance or radio removal, the time set-
ting will be cleared. If this occurs, it is necessary to reset the time.
To Next Page
Loading...
