FORESTER U.S.A. (E)
5
Audio
5-3
– CONTINUED –
HS5001BBHS0084
The antenna and the special wrench for mounting/removing the
antenna is stored in the luggage floor storage tray at the front side.
1. Remove the plug from the antenna base.
2. Remove the cap at the threaded portion of the antenna.
3. Install the antenna to the antenna base while turning the antenna
clockwise by hand.
HS5002BBHS0085
Tighten
Loosen
4. Tighten the antenna using the special wrench. Do not use an ordi-
nary wrench that is longer than special wrench.
5. To remove the antenna, follow the installation sequence in reverse.
Be careful not to lose the special tool.
Make sure that the antenna is fully tightened before operating your
vehicle.
To Next Page
Loading...
