FORESTER U.S.A. (E)
6-10
HS6006BB
1. Turn on the ignition switch to the “ACC” position and the display
shows the default English measurement units.
2. Depress the “ADJ” switch for 5 seconds or more and the display
will show “DEVIATION” together with the “5” and “W”.
HS6007BB
3. Change the measurement units by pressing the “MODE” switch
until the proper mode appears.
4. Press the “ADJ” switch to save your selection.
NOTE
D If the setting is not completed in 30 seconds, the display will
return to the initial mode.
D When the battery is disconnected, you may have to perform
this operation again to reset to the desired units.
To Next Page
Loading...
