FORESTER U.S.A. (E)
6
Interior equipment
6-13
– CONTINUED –
HS6011BBHS6010BA
1) Press the “ADJ” switch for the compass setting mode.
NOTE
D The compass starts blinking in this mode.
D This mode can be canceled by pressing the “ADJ” switch
again.
2) Make certain that it is safe to do so and then drive the vehicle in a
circle until the compass stops blinking. You may have to complete
more than one circle to perform this calibration.
NOTE
D When setting is completed, all blinking disappears.
D The setting mode is automatically cancelled if the “ADJ”
switch is pressed in the middle of setting or if the setting is not
completed within 2 minutes.
The motion indicator bars move in two patterns according to the
vehicle speed.
To Next Page
Loading...
