Legacy U.S.A..(ENG.)A2290BE–A
2
Keys and doors
2-11
– CONTINUED –
To enter the programming mode:
HB1005BCHB1000CB
1 Press to dis-
arm the security
system (if so
equipped).
2
3
1. Disarm the security system. (if your vehicle is equipped with the
optional security system.)
2. Open the driver’s door and sit in the driver’s seat.
3. Close the driver’s door.
HB2032BB
4. Place the ignition key into the ignition switch and cycle the switch
from LOCK to ON ten times within 15 seconds. Be sure to stop at the
LOCK position. The horn will sound once to indicate that you are in
the transmitter programming mode.
NOTE
You must finish the next step (opening the driver’s door) within
45 seconds of starting this procedures.
To Next Page
Loading...
