Legacy U.S.A..(ENG.)A2290BE–A
1
Seat, seatbelt and SRS airbags
1-27
– CONTINUED –
HB1037BAHB1036BA
1. Insert a key or other hard pointed object into the slot in the con-
nector (buckle) on the right-hand side and push it in, and the connec-
tor (tongue) plate will disconnect from the buckle.
HB1048BAHB1038CA
2. Allow the retractor to roll up the belt. You should hold the webbing
end and guide it back into the retractor while it is rolling up. Neatly
store the tongue plates in the recess in the retractor and then insert
the connector (tongue) plate into the slot located at the front of the
recess.
NOTE
When folding down the rear seat cushion, store the seatbelts in
the seatbelt pocket to prevent them falling below the cushion.
To Next Page