– 10 –
Step Parts to remove Remarks and procedures Fasteners
19
Connecting rod and
piston
(1) Remove connecting rod bolts and connecting
rod cap.
(2) Turn crankshaft until piston comes to top dead
center, push out connecting rod and piston
assembly through top of cylinder.
* Scrape off all carbon deposits that might interfere
with removal of piston from upper end of cylinder.
M5 x 25 : 2 pcs.
8 mm box spanner
Piston and piston pin (1) Remove clips and piston pin to remove
connecting rod from piston.
(2) Remove piston rings from piston.
* Be careful not to damage the piston and
connecting rod.
Be careful not to break rings by spreading too
much or twisting.
M5 x 25 CONNECTING ROD BOLT : 2 pcs.
P.T.O. shaft side
To Next Page
Loading...
