Subaru ER12 - Page 35

- 31 -
(6) CYLINDER HEAD
(a) Inspect and repair any scratches on mounting surface and replace head gasket to new one before installing
(b) Insert the pipe knocks between crankcase and cylinder head
Install cylinder head onto cylinder with new head gasket
Apply oil to the screw thread
Tighten four flange bolts evenly in three steps by the following tightening torque:
Cylinder head M8×98mm bolt : 4pcs
(7) SETTING THE TIMING BELT
(a) Set the crankshaft to the top dead center
(b)
Set the timingbelt to the drive pulley on the crankshaft
(c) Install the campulley to the cylinder head
Meet the matching mark of campulley and
cylinder head
(d) Mounting the campulley on the cylinder head
Mount the campulley on the cylinder head by
inserting the pin (campulley)through the head
Fix the bolt to prevent the pin (campulley) from
coming out
M6×8mm flange bolt : 1pc
Tightening torque
1 st step 2 st step Final step
50 N
・
m
(50
kgf
・
cm )
(36 ft
・
lb)
98 N
・
m
(100 kgf
・
cm )
(72 ft
・
lb)
200 - 240 N
・
m
(200 - 240 kgf
・
cm )
(144 - 177 ft
・
lb)
Tightening torque
40 - 60 N
・
m
(40 - 60
kgf
・
cm )
(29 - 43 ft
・
lb)
TIMING BELT
CAMPULLEY
DRIVE
PULLEY
CRANKSHAFT
Matching mark
Cylinder head surface
PIN(CAMSHAFT)
M6 x 8
FLANGE BOLT : 1pc.
O-RING
CYLINDER HEAD