Black plate (170,1)
一般Model "A2440GE-A" EDITED: 2007/ 6/ 15
3-40 Instruments and controls
! List of warnings
Inside warning
chime
Outside warning
chime
Access key
warning light on
meter
Operation indi-
cator on push-
button ignition
switch
Status Action
Ding,
ding ...
(intermittent)
———
The driver’s door was opened while
the power is “Acc” (in AT vehicles,
when the selector lever is in the “P”
position).
Switch the power to “OFF”, or close
the driver’s door.
*When exiting the vehicle, be sure
to switch the power to “OFF”.
The power was switched to “OFF”
while the driver’s door is open.
Close the driver’s door.
—
Short beep
(2 seconds)
——
An attempt was made to lock all
doors while the access key is left
inside the vehicle.
Take out the access key from the
vehicle, and lock the doors.
*The doors cannot be locked while
the access key is inside the vehicle.
*A chirp sound will be heard, and all
doors will be unlocked.
The trunk was closed with the
access key in it while all doors are
locked (or during the automatic lock
time period) (Sedan).
Take out the access key from the
trunk, and close the trunk.
*By pressing the trunk opener but-
ton after this warning chime sounds,
the trunk can be unlocked.
The door lock/unlock button was
pressed while the power is “OFF”
and the access key is inside the
vehicle.
Take out the access key from the
vehicle, and lock the doors.
*If the access key is inside the
vehicle, the doors cannot be locked.
—
Beep
(10 seconds)
——
The push-button ignition switch is
pushed while the ignition switch is
in the “OFF” position and one of the
doors including the rear gate is
open.
Close the doors securely and lock
them.
*If one of the doors is open includ-
ing the rear gate, the doors cannot
be locked.
To Next Page
Loading...
Need help?
General
