Black plate (318,1)
一般Model "A2440GE-A" EDITED: 2007/ 6/ 15
7-50 Starting and operating
& Vehicle Dynamics Control
OFF switch
Left-hand drive vehicles
Right-hand drive vehicles
Pressingtheswitchtodeactivatethe
Vehicle Dynamics Control system can
facilitate the following operations:
. a standing start on a steeply sloping
road with a snowy, gravel-covered, or
otherwise slippery surface
. extrication of the vehicle when its
wheels are stuck in mud or deep snow
When the switch is pressed during engine
operation, the “
” indicator light illumi-
nates. The Vehicle Dyna mics Control
system will be deactivated and the vehicle
will behave like a model not equipped with
the Vehicle Dynamics Control system.
When the switch is pressed again to
reactivate the Vehicle Dynamics Control
system, the indicator light goes off.
With the Vehicle Dynamics Control system
deactivated, traction and stability en-
hancement offered by Vehicle Dynamics
Control system is unavailable. Therefore
you should not deactivate the Vehicle
Dynamics Control system except under
above-mentioned situations.
NOTE
. When the switch has been pressed
to deactivate the Vehic le Dynam ics
Control system, the Vehicle Dynamics
Control s ystem automatical ly reacti-
vates itself the next time the ignition
switch is turned to the “LOCK (off)”
position and the engine is restarted.
. If the switch is held down for 10
seconds or longer, the indicator light
goes off, the Vehicle Dynamics Control
system is activated, and the system
ignores any further pressing of the
switch. To ma ke the switch usable
again, turn the ignition switch to the
“LOCK (off)” position and restart the
engine.
. Whentheswitchispressedto
deactivate the Vehicle Dynamics Con-
trol system, the vehicle ’s running per-
formance is comparable with that of a
vehicle that does not have a Vehicle
Dynamics Control system. Do not de-
activate the Vehicle Dynamics Control
system except when absolutely neces-
sary.
To Next Page
Loading...
Need help?
General
