北米Model "A2600BE-B" EDITED: 2020/ 10/ 1
be erased for security purposes.
Refer to “Erasing HomeLink
®
but-
tons” FP267.
! Programming a New HomeLink
®
button
s03ap100301
1) Indicator Light
2) HomeLink
®
buttons
1. Press and release the HomeLink
®
button that you would like to program.
The HomeLink
®
indicator light will flash
orange slowly (if not, refer to “Erasing
HomeLink
®
buttons” FP267).
1) Garage door opener remote
2. Position the hand-held remote (garage
door opener remote) 1 to 3 inches (2 to 8
cm) away from the HomeLink
®
button that
you would like to program.
NOTE
Some hand-held remotes (garage door
opener remotes) may actually train
better at a distance of 6 to 12 inches
(15 to 30 cm). Keep this in mind if you
have difficulty with the programming
process.
3. While the HomeLink
®
indicator light is
flashing orange, press and hold the hand-
held remote button. Continue pressing the
hand-held remote button until the
HomeLink
®
indicator light changes from
orange to green. You may now release the
hand-held remote button.
NOTE
Some devices may require you to re-
place this “Programming a New
HomeLink
®
button” step 3 with proce-
dures noted in the “Gate Operator /
Canadian Programming” section. Refer
to “Gate Operator/Canadian Program-
ming” FP267.
– CONTINUED –
Mirrors
265
3
Instruments and Controls
To Next Page
Loading...
