北米Model "A2600BE-B" EDITED: 2020/ 10/ 1
NOTE
The tightening torque is approximately
8.9 + 2.2 lbf·ft (12 + 3.0 N·m, 1.2 + 0.3
kgf·m).
7. Install the plastic plug by pushing it into
the hole until it is fully seated.
! How to re-stow bars
s08aj0803
CAUTION
Do not use the bars as roof rails
when the bars are stowed.
1. Check that the rear crossbar is stowed
in the front side holder.
2. Pull out the crossbars from the roof rail
holders by pulling up the covers.
3. Slide the bars in the direction shown in
the illustration.
4. Install the bars into the holders.
5. Make sure that the latches are fitted
securely.
Loading Your Vehicle
435
8
Driving Tips
To Next Page
Loading...
