北米Model "A2600BE-B" EDITED: 2020/ 10/ 1
threaded hole until its thread can no longer
be seen.
4. Tighten the towing hook securely using
the jack handle and wheel nut wrench.
After towing, remove the towing hook from
the vehicle and stow it in the under-floor
storage compartment.
Fit the towing hook cover on the bumper.
WARNING
. Do not use the towing hook for
purposes other than towing your
vehicle.
. Be sure to remove the towing
hook after towing. Leaving the
towing hook mounted on the
vehicle could interfere with prop-
er operation of the fuel pump
shut off function when the vehi-
cle is struck from behind.
CAUTION
To prevent deformation to the bum-
per and the towing hook, do not
apply excessive load to the towing
hook.
Front tie-down hooks:
The front tie-down hooks are located
between each of the front tires and the
front bumper.
Front Tie-down Hooks are for tying down
the vehicle. They are not for towing.
Rear tie-down holes:
1) Rear tie-down hole
The rear tie-down holes are located near
each of the jack-up reinforcements.
There is a plug in each rear tie-down hole.
To use the rear tie-down holes, remove the
– CONTINUED –
Towing
463
9
In Case of Emergency
To Next Page
Loading...
