北米Model "A2600BE-B" EDITED: 2020/ 10/ 1
2.4 L models
1) Oil level gauge
2) Oil filler cap
3) Oil filter
CAUTION
If the level gauge is not pulled out
easily, twist the level gauge right and
left, then pull it out. Otherwise, you
may be injured accidentally strain-
ing yourself.
2. Pull out the level gauge, wipe it clean,
and insert it again.
3. Be sure the level gauge is correctly
inserted until it stops.
2.5 L models
1) Full level
2) Low level
3) Approximately 1.1 US qt (1.0 liter, 0.9 Imp
qt) from low level to full level
2.4 L models
1) Full level
2) Low level
3) Approximately 1.1 US qt (1.0 liter, 0.9 Imp
qt) from low level to full level
4. Pull out the oil level gauge again.
5. Check the oil level on the gauge. If the
oil level is below the low level mark, add oil
so that the full level is reached.
CAUTION
. Be careful not to touch the engine
oil filter when removing the oil
filler cap. Doing so may result in a
burn, a pinched finger, or may
cause some other injury.
. Use only engine oil with the
recommended grade and vis-
Engine Oil
492
To Next Page
Loading...
