Subcold SUPER Series - Important Safety Warnings

• Cauon When Posioning: Ensure the appliance's power cable is neither trapped nor damaged
during posioning.
• Power Socket: Refrain from posioning portable power sockets or cables at the rear of the
appliance.
• Child Entrapment Risk: Exercise cauon to prevent the risk of child entrapment.
• Venlaon Clearance Warning: Maintain adequate venlaon openings around the appliance; it
should remain unobstructed without any door coverings.
• Refrigerant Circuit Warning: Avoid damaging the refrigerant circuit.
• Defrosng Cauon: Use only recommended methods to defrost; sharp objects or other tools may
cause permanent damage.
• Electrical Appliance Use Warning: Refrain from using electrical appliances inside the fridge unless
manufacturer recommended.
• Disposal Precauons: Before disposing of the appliance, remove doors and leave shelves in place.
• Flammable Materials Cauon: Never allow children to interact with the appliance, avoid cleaning
with ammable liquids, and keep ammable materials away from the appliance.
• Cleaning Instrucons: Use non-abrasive cleaners or soapy water for cleaning; avoid solvents.
• Fire Hazard Symbol: Symbol ISO 7010 W021 indicates a re hazard.
• Venlaon Clearance: Maintain a minimum of 3-5cm clearance at the top of the appliance, and a
3-5cm clearance on each side of the appliance for proper venlaon and heat dissipaon.
• Door Openings: Minimise the me the door is open to maintain a stable temperature.
• General Installaon Guidelines: Avoid heat sources and direct sunlight, install on a at, clean,
stable surface, and refrain from placing other electrical equipment on the appliance.
• Damp Environment Warning: Ensure the appliance is not placed in damp areas.
• Perishable Food Storage: Avoid storing perishable food in this appliance for extended periods of
me, as the indoor temperature may not be suciently cold for proper storage.
• Circuitry and Power Plug:
• The circuitry for the refrigerator must be isolated. The area of cross secon of wire must be
larger than 0.75mm.
• The power plug should have its own socket, grounded, as an adapter may cause the socket to
overheat.
• The voltage and frequency of this product should be 220-240V;50Hz. Contact a qualied local
electrician or retailer in case of electrical cord damage.
• Always disconnect the power by pulling the power plug out of the socket directly and not by
the cord.
Important Safety Warnings
V1 3