Subcold SUPER Series - Operating Instructions

Before Pung Your Appliance Into Use
• Remove all inner and outer packaging components, including adhesive transport tapes.
• Verify that none of the following are missing:
• Removable Shelves
• Operang Manual
• Set of 2 Keys
• Allow the appliance to stand upright for a minimum of 2 hours before connecng it to a power
supply. This minimises the risk of refrigeraon system malfuncon due to transport & handling.
• Clean the inner surfaces of the unit with a so cloth and warm, soapy water. Avoid using any
abrasive cleaners or solvents.
• Place the unit on a stable surface that can withstand its weight, making sure to adjust the front
feet for stability. Ensure the surface is rm, at, and level to reduce noise and vibraon. Tighten
the adjustable legs to the oor and lt the appliance slightly backward to ensure the door closes
ghtly.
• Install the appliance away from direct sunlight and heat sources to prevent damage to the
coang and reduce power consumpon. Extreme temperatures can aect proper operaon.
• Maintain a minimum of 3-5cm clearance at the top of the appliance, and a 3-5cm clearance on
each side of the appliance for proper venlaon and heat dissipaon.
• Do not install the unit in unheated buildings, outbuildings, or garages.
• This unit is for indoor use only.
• Before connecng the unit to the power supply, ensure the drip tray above the compressor is
properly posioned.
Cauon: Keep the unit away from any substances that may cause combuson.
Operang Instrucons
V1 5