Subcold SUPER Series - Page 6

Seng the Temperature Control
The refrigerator's temperature can be manually adjusted using the
control dial. A higher number on the thermostat corresponds to a
colder inside temperature.
Your unit features a single control dial for regulang the temperature
in the compartment, located at the lower right side.
For inial use, set the temperature dial to 5. Aer 24 hours, you can
adjust it to suit your needs. "3" and "4" are recommended sengs for
home or oce use.
To switch o the appliance, turn the dial to "0."
The temperature range is 3-18°C.
Note:
Turning the dial to "0" stops the cooling cycle but does not disconnect the unit's power.
If the unit is unplugged or turned o, wait for 3 to 5 minutes before restarng to avoid
malfunconing.
Door Reversal
1. Use a athead screwdriver to gently prise up and slide forward the top hinge cover on the right
side, removing it.
2. Ulise a baery drill with a 'Phillips head' to unscrew the three screws securing the top hinge,
then li o the hinge and set it aside.
3. Carefully li the door straight upwards and place it to one side.
4. Lay the fridge on its back to access the three screws holding the boom hinge. Remove these
screws with the baery drill.
5. Aach the boom hinge to the opposite side, using the same hole paern as before.
6. Place the door back onto the boom hinge pin.
7. Before re-ng the top hinge on the fridge's top, remove the blanking plate.
8. Ensure the door is level and straight, then use the baery drill to securely ghten the screws
back into place.
9. Return the fridge to an upright posion and wait 2-3 hours before switching it back on.
V1 6
Operang Instrucons