SPEAKER:
2 - 8Ω outputs wired in parallel
IMPORTANT: To avoid damage to your amplifier, do not operate without
turning down Corso’s Power control to it’s minimum setting (0) or
connecting it to a suitable speaker load. !
LINE OUT:
Unbalanced !¼” Output. Use this to connect the Corso to a mixer or
recording device.
NOTE: The Corso’s Line Out is full range (not compensated) and offers
the sound of the entire amplifier, not just the pre-amp section. To fully
experience all of the Corso’s tone when plugging directly into a I/O device
we advise the use of filtering (cabinet emulator) or impulse responses
when using the Corso to record direct.
BACK PANEL
To Next Page
Loading...
