Sullair 375H - Page 47

SECTION 2 300HH, 375, 375H, 375HH, 425 AND 425H USER MANUAL R00
45
from this list can be selected to replace any
or all of the default parameters.
5. To reset the display parameters to the factory
defaults, scroll to and highlight USE
DEFAULTS. Press the ENTER key to acti-
vate the USE DEFAULTS function. A mes-
sage indicating the display parameters are
reset to the factory defaults will be displayed,
then the display will return to the SETUP 4-
UP DISPLAY menu.
6. Custom Setup – To perform a custom setup
of the SETUP 4-UP DISPLAY, use the arrow
buttons to scroll and highlight CUSTOM
SETUP on the display.
7. The quadrant with the highlighted parameter
value is the current selected parameter. Use
the arrow keys to highlight the value in the
quadrant you wish to change to a new
parameter.
8. Press the ENTER key and a list of engine
parameters will be displayed.
9. The parameter that is highlighted is the
selected parameter for the screen. Use the
arrow keys to highlight the new parameter to
be placed in the SETUP 4-UP DISPLAY.
PV101 SU_0000558
USE DEFAULTS
CUSTOM SETUP
Select Factory Defaults
Figure 2-81
PV101 SU_0000559
RESTORED TO
DEFAULTS
Restored to Defaults
Figure 2-82
PV101 SU_0000560
USE DEFAULTS
CUSTOM SETUP
Custom Setup
Figure 2-83
Select Parameters
PV101 SU_0000561
1000 RPM
ENG RPM
57 PSI
57 F
COOL TEMP
12.4 VDC
BAT VOLT
OIL PRES
Figure 2-84
List of Engine Parameters
PV101 SU_0000562
1000 RPM
ENG RPM
57 PSI
57 F
COOL TEMP
12.4 VDC
BAT VOLT
OIL PRES
Figure 2-85
Select Desired Engine Parameter
PV101 SU_0000563
Note the number to the
right of the selected
parameter indicates the
quadrant in which it is
displayed.
1 = Upper Left Quadrant
2 = Lower Left Quadrant
3 = Upper Right Quadrant
4 = Lower Right Quadrant
ENGINE OIL PRESSURE
FUEL RATE
INTAKE TEMPERATURE
BATTERY POTENTIAL VOLTAGE
ENGINE DESIRED OP SPEED
MACHINE HOURS
3
4
2
Figure 2-86