63
375 John Deere Standard and Aftercooled/Filtered Operator’s Manual and Parts List
Section 5
MAINTENANCE
GENERAL5.1
Consistent and correctly performed maintenance will
ensure the compressor’s performance and extend its
operational life. See Part Replacement and Adjustment
Procedures on page 65 for a detailed description of
specic compressor components. Before performing
maintenance actions, read the CIMA Safety Manual, if
applicable. For engine maintenance requirements and
procedures, refer to the Engine Operator’s Manual.
DAILY MAINTENANCE5.2
See Initial Startup Shutdown/Procedure on page 62 for
general operation.
WARNING
Follow lockout/tagout procedures of
Section 1 SAFETY.
WARNING
DO NOT remove caps. Plugs
and/or other components when
the compressor is running or
pressurized. Shutdown the
compressor before removing any
components.
NOTE
Dispose of uids in accordance with
applicable federal, state and local
regulations.
CAUTION
The radiator and engine cooling
system must be drained and ushed
periodically. Refer to the OEM Engine
Manual for more information. Replace
the coolant with a solution of 50%
ethylene glycol and 50% water or as
required for your geographic location.
DO NOT use a leak sealing type of
antifreeze. Should a 100% water
solution be used, a non-chromate
rust inhibitor must be added. DO NOT
mix coolant types.
To Next Page
Loading...
