Sullair DE-18 - Page 47

SECTION 4 DE-18 USER MANUAL
47
Figure 4-12: Compressor Piping and Instrumentation Diagram
KEY
NO.
Q
T
Y
DESCRIPTION
1 1 Pre-Filter, Air
2 1 Valve, Butterfly 8”
3 1 Cylinder, Hydraulic 2” Stroke
4 1 Valve, Pneumatic Blowdown
5 1 Unit, First Stage
6 1 Manifold, Silencer
7 1 Intercooler, Air-Cooled
8 1 Aftercooler, Air-Cooled
9 1 Unit Second Stage
10 1 Silencer, Air 4” Flanged
11 1 Filter, Air Control line
12 1 Separator, Water Comb 4”
13 1 Valve, Check 4”
14 1 Valve, Relief Second Stage
15 1 Strainer, Suction 1”FNPT
16 2 Silencer, Blowdown
17 1 Manifold, Oil
18 1 Valve, Thermal Mixing
19 1 Filter, Air
20 1 Pressure, Regulator
21 1 Pressure, Gauge
22 1 Valve, Relief First Stage
23 1 Pump, Oil Internal
24 1 Probe, RTD 100 OHM 3.5”
25 1 Oil Cooler
26 2 Probe, RTD 100 OHM 3.5”
27 1 Heater, Sump Tank
28 4 Transducer, Press. 0-200#
29 1 Valve, Ball 3/4” NPT
30 2 Glass, Oil Level Sight 1 1/16—12 SAE
31 1 Filter, Tank Vent Oil Mist
32 1 Valve, Solenoid 4-way
33 1 Switch, Vacuum
34 1 Tank, Sump Assy, Oil Sump Integral
35 1 Relief Valve
36 2 Valve, Ball Check 1/2”
37 2 Strainer, V-Type 300PSI 1/2”
38 2 Drain Valve, Solenoid 1/2” 2WNC 200# M.O.
39 3 1/2” Ball Valve
40 1 Orifice, 1/2”M x 1/2”F .265 DIA. (6.731mm)
41 1 Oil Filter Element
42 1 Valve, Relief 20-150 PSI
43 1 Valve, 3-Way Solenoid 24V DC
44 1 Plug, Oil Fill 1 1/16—16 SAE
45 1
46 1 Heater, Discharge COndensate Trap
47 1 Switch, Vacuum
48 1 Gauge, Pump Discharge Pressure
49 3 Probe, RTD 100 OHM 6”
50 1 Valve, 4” Non-Vented Ball
51 1 Valve, Check Inline1/4” NPT
52 1 Hose, Oil Cooler
53 1 Hose, Oil Cooler
54 1 Hose, Oil Cooler
55 1 Hose, Intercooler Condensate
56 1 Hose, Intercooler Condensate
PLEASE NOTE: WHEN ORDERING PARTS,
INDICATE SERIAL NUMBER OF
COMPRESSOR