Figure 4-1: Recommended Installation
Table 4-1: Dryer Specifications
Model No. ____________________________________ Desiccant/Tower: ____________ LBS ____________
Serial No._____________________________________ Inlet/Outlet Size: ____________ NPT ____________
Inlet Design Conditions: _________________________ Cycle Time: ___________ Standard Short Cycle _______
Flow: ________________________SCFM@
Pressure: ___________ 100 ________PSIG
Maximum Operating Pressure: ________________ PSIG
Temperature: ________ 100 ________°F
Minimum Operating Pressure: ________________ PSIG
Outlet Dew Point: _________°F PDP @ Above Conditions Maximum Operating Temperature: _________________°F
Purge Flow: __________ PSIG/SCFM _____________ Minimum Operating Temperature: _________________°F
Power Supply: _________V_________PH_________HZ
Current Draw: _____________ AMP ________________
1. This pressure is 95% of MAWP
2. Operating at “OFF” design conditions may adversely affect Outlet Dew Point.
3. Operation of dryer below 35°F requires heat tracing of certain components upstream of dryer outlet.
To Next Page
Loading...
