Sullair SRL-16.5MB - Maintenance and Inspection; Daily Maintenance and Inspection Procedures

Subject to EAR, ECCN EAR99 and related export control restrictions. 02250236-267 R02
■ Daily inspections of the SRL air compressor are imperative to long safe operation. Review the total
operating hours on the control panel of the air compressor with the operation time schedule shown on
the table below and carry out the inspection at the proper time intervals.
■ Maintenance and Inspection Time Interval indicates the time for maintenance and inspection, not the
guaranteed time of the air compressor or parts.
Component
Inspection
Instructions
Maintenance and Inspection Time Interval
Remarks
Daily
Every
500 Hours
or 2 Months
Every
2,500 Hours
or 1 Year
Every
5,000 Hours
or 2 Years
Every
10,000Hours
or 4 Years
Every
20,000Hours
or 8 Years
Air Receiver Tank
(Option)
Drain accumulated
condensate in air receiver.
○
Complete Air
Compressor
Remove accumlation of dust
and/or dirt.
○
Inspect for excessive noise
and vibration.
○ Refer to page 25.
Safety Relief Valve Inspect operation. ○
Replace the safety relief
valve if there is any
damage.
Pressure Sensor
Inspect operation and confirm
valid pressure displayed.
○
Replace the sensor if
there is any damage.
Check Valve Inspect for leaks or replace. ○ ●
Ventilating Fan
Inspect or replace
the ventilating fan.
○ ● Refer to page 26.
Bolts, Nuts & Screws
Inspect and tighten any
loose items.
○ Refer to page 26.
Intake Air Filter
Replace a dirty or
clogged filter.
○ ● ◎ Refer to page 26.
Sirocco Fan & Scroll
Fin
Clean the dirt off
these components.
○ ◎
Scroll Bearing
Grease or inspect
the bearing.
○ ◎
Replace the scroll head if
there is any damage with
bearing.
Tip Seal & Face Seal Replace the seals. ● ◎
Bearings Inspect the bearings. ○ ◎
Replace the scroll head if
there is any damage with
bearings.
Scroll Head
Replace the scroll
head.
●
Rubber Hose Inspect for leaks. ○ ●
Replace the rubber
hose if there is any
damage.
V-Belts
Inspect, adjust and/or replace
a loose or damaged v-belt
○ ● Refer to page 27.
Electromagnetic
Contactor
Inspect or replace. ○ ●
Rubber Vibration
Isolator Pads
Inspect for any damage
and/or hardness.
○
Replace the pads if
there is any damage.
Electric Main Motor Inspect for any damage. ○
Replace the motor if
there is any damage.
Coolers
Clean the dirt off or
replace.
○ ●
Maintenance and Inspection
【122PSIG Model】
21
Note: Legend for Maintenance and Inspect items listed at the bottom of page 22.