What should I do if my Sullair Air Compressor displays a pressure sensor error?
Tighten the pressure sensor wire and reset the air compressor. If the error re-occurs, contact the local Sullair distributor to replace the pressure sensor.
How to reduce excessive noise from my Sullair SRL-16.5MB?
Excessive noise may be due to several factors. Ensure the air compressor is installed on level ground according to the installation procedure. Check if transport fixtures were not removed and remove them. Also, re-tighten or replace the V-belt if it is loose. If the rubber vibration isolators are worn, they should be replaced. For issues related to the SRL reverse rotation, scroll head failure, or electric motor failure, contact your local Sullair distributor.
What to do if my Sullair SRL-16.5MB Air Compressor has low discharge pressure?
Low discharge pressure can be caused by a few things. First, check for leaks in the internal air compressor piping and re-tighten all the air compressor pipe fittings. If the safety relief valve is leaking, replace it. A clogged or dirty intake air filter can also cause this issue, so replace the intake air filter element. For check valve failure, contact the local Sullair distributor.
What causes high discharge pressure in my Sullair SRL-16.5MB?
High discharge pressure can be caused by a printed circuit board failure or electromagnetic contactor failure. Contact the local Sullair distributor to replace these components.
Why is the electric motor overheating in my Sullair SRL-16.5MB Air Compressor?
Overheating of the electric motor may be due to a failed motor bearing, a worn seal, or a short-circuited motor. Contact the local Sullair distributor to replace the electric motor.
How do I fix a phase reversal error on my Sullair Air Compressor?
To fix a phase reversal error, change two of the three incoming power cables.
How to troubleshoot an ambient temperature sensor error on a Sullair SRL-16.5MB Air Compressor?
Check the temperature sensors and the wiring to verify that they are not broken and the connectors are not disconnected. Reset the air compressor, and if the error re-occurs, contact the local Sullair distributor.
What does the maintenance alarm mean on my Sullair SRL-16.5MB Air Compressor?
This alarm is displayed when the total operating hours exceed 2,500 hours. Carry out inspection and maintenance of the air compressor.
What does the scroll head maintenance alarm indicate on my Sullair Air Compressor?
This alarm shows when the total operating hours exceed 9,500 hours (145PSIG Model : 4,500 hours). Perform an inspection and maintenance of the scroll head.
What triggers the overhaul alarm on my Sullair SRL-16.5MB Air Compressor?
This alarm appears when the total operating hours exceed between 19,000 to 19,500 hours (145PSIG Model : between 13,500 to 14,500 hours). Carry out overhaul of the Scroll Head.
Guidelines for safely installing the air compressor in various environments.
Essential safety measures for operating the air compressor equipment.
Safety protocols for performing maintenance and inspection on the compressor.
Procedures to verify the correct model and included items upon delivery.
Guidelines and precautions for moving the air compressor safely.
Instructions for proper placement, ventilation, and spacing for installation.
Explanation of error codes and alarms displayed on the digital panel.
Troubleshooting for optional function error codes and alarms.
General| Brand | Sullair |
|---|---|
| Model | SRL-16.5MB |
| Category | Air Compressor |
| Language | English |
To Next Page