Sullivan-Palatek 20D - Receiving and Initial Inspection; Moving and Lifting Procedures; Location, Support, and Air Requirements; Ventilation and Cooling Considerations

38 INSTALLATION
4.1 RECEIVING
Every Sullivan-Palatek
testing ensures that the air compressor is functioning properly and will deliver its rated pressure and







4.2 MOVING AND LIFTING



WARNING! Keep personnel out from under and away from the area when moving or liing the compressor.
CAUTION! 




4.3 LOCATION AND SUPPORT
Install the compressor on a level, hard surface capable of supporting its weight in a clean, well-lit and


When installing on a mezzanine, ensure there is proper beam and brace support for the compressor’s weight


NOTE! Refer to Technical Data on page 6 for the compressor’s dimensions, weight and other specs that must be
accommodated.
4.4 INTAKE AIR


following guidelines:
» 
» 

» 
» 
» 
4.5 VENTILATION AND COOLING
The location where the compressor is installed must have adequate ventilation to maintain the rated


CAUTION! Do not install a compressor without adequate freeze protection where it will be exposed to

NOTE! Heat rejection is the amount of heat radiated by the compressor. Fan air ow is the required volume of air
per unit time which must ow through the compressor for proper ventilation.