6 Cyclo® BBB4 Quick Start Guide
5
Inspect and test Taper-Grip® bushing on shaft.
• Check shaft for burrs, corrosion, or warpage. Repair or
replace shaft as necessary.
• Slide bushing back and forth along shaft, checking for
surface irregularities and fit.
• Verify bushing is sized correctly for the shaft diameter.
6
Remove Taper-Grip® bushing from driven shaft.
7
Apply a thin layer of anti-seize grease to the male threads of the
Taper-Grip® bushing only.
Ensure that the anti-seize grease does not enter the Taper-
Grip® bushing bore.
Do not apply anti-seize grease to the female threads in the
hub.
Apply thin layer of
anti-seize grease to male
threads of bushing only.
Do not apply anti-seize grease
to the female threads in the
hub.
To Next Page
Loading...
