Quick Start Guide Cyclo® BBB4 7
8
Screw Taper-Grip® bushing into Cyclo® BBB4 leaving approximately
1 mm gap between the bushing flange and thrust collar.
Do not apply grease, oil, or anti-seize grease to the
driven shaft or the bushing bore before placing the unit
onto driven shaft. Use of these friction-minimizing products
will adversely affect the ability of the unit to transmit
torque.
CAUTION: The Cyclo® BBB4 must be externally supported
prior to insertion of driven shaft into bushing. External
support MUST be maintained until all bushing socket
head cap screws have been tightened to the appropriate
operational torque.
9
Mount or slide the Cyclo® BBB4 onto the driven shaft
Do not rock or pry the unit.
10
Screw Bolts into Taper-Grip® bushing.
• Lightly oil threads of each bolt before inserting.
• Finger tighten each bolt to secure in place.
• Be sure to maintain the 1 mm (approximate) gap
between the thrust collar and the bushing flange.
Feeler Gauge
Bushing
Flange
Thrust Collar
To Next Page
Loading...
