Sumitomo HF-520 Series - Page 7

6
Table of Contents
Types of Auto-Tuning ................................................................................... 107
Before Auto-Tuning the Drive ...................................................................107
Auto-Tuning Interruption and Fault Codes .......................................... 109
Performing Auto-Tuning .............................................................................109
Auto-Tuning Example ..................................................................................111
Input Data for Auto-Tuning........................................................................113
4.8 No-Load Operation Test Run ............................................117
No-Load Operation Test Run ..................................................................... 117
4.9 Test Run with Load Connected .........................................119
Test Run with the Load Connected ......................................................... 119
4.10 Test Run Checklist .............................................................120
5. Troubleshooting ......................................................123
5.1 Drive Alarms, Faults, and Errors .......................................124
Types of Alarms, Faults, and Errors .......................................................... 124
5.2 Fault Detection ..................................................................125
Fault Displays, Causes, and Possible Solutions ...................................125
5.3 Alarm Detection ................................................................146
Alarm Codes, Causes, and Possible Solutions .....................................146
5.4 Operator Programming Errors .........................................149
oPE Codes, Causes, and Possible Solutions ..........................................149
5.5 Auto-Tuning Fault Detection ............................................150
Auto-Tuning Codes, Causes, and Possible Solutions ........................ 150
5.6 Diagnosing and Resetting Faults .....................................153
Fault Reset Methods ..................................................................................... 153
A. Specications ..........................................................155
A.1 Heavy Duty and Normal Duty Ratings .............................156
A.2 Single/Three-Phase 200 V Class Drive .............................157
A.3 Three-Phase 400 V Class Drives .......................................161
A.4 Drive Specications ..........................................................163
B. Parameter List .........................................................167