2.6
SECTION 2 - SPRAYER OPERATION
12. FOLD BOOM FROM FIELD TO TRANSPORT POSITION.
A. Activate vertical height switch and raise booms completely.
B. Deactivate vertical height switch.
C. Activate part 3 boom switch and fold part 3 boom, if equipped..
D. Deactivate part 3 boom switch.
E. Activate part 2 boom switch and fold part 2 booms.
F. Deactivate part 2 boom switch.
G. Activate right and left tip lift switches together or separately and raise tip lifts.
H. Deactivate tip lift switches.
I. Activate part 1 boom fold switch and fold part 1 booms.
J. Deactivate part 1 boom switch.
K. Activate vertical height switch and lower booms to transfer ALL weight of booms onto transport
supports.
13. ADJUSTMENTS FOR TRANSPORT
A. Park sprayer on a level surface.
B. Adjust boom fold travel.
1. Fold sprayer booms up to
transport rest.
2. Inner boom should just make
contact with transport rest in-
ner stop.
WARNING!
PART 1 BOOM FOLD CYLINDERS ARE MOUNTED WITH A SPRING CLEVIS ASSEMBLY.
THE CLEVIS WILL ALLOW 5/8” OF AN INCH OF CYLINDER MOVEMENT. THE SPRING
MUST BE TIGHTENED TO ALLOW FOR FULL TRAVEL WITHOUT THE COILS COMING
IN CONTACT WITH EACH OTHER.
NOTE!
OUTER MOST BOOMS MUST BE COMPLETELY FOLDED BEFORE ANY INNER BOOMS
WILL MOVE. IF INNER BOOMS DO NOT MOVE VERIFY THAT OUTER BOOMS HAVE
FOLDED COMPLETELY AND CLOSED SAFETY SWITCH LOCATED NEAR RIGHT BOOM
MID-HINGE.
WARNING!
WHEN SPRAYER IS TOWED WITHOUT A TRACTOR, BOOMS SHOULD BE SECURED
TO TRANSPORT RESTS. THIS IS EASILY ACCOMPLISHED BY RUNNING A STRAP BE-
TWEEN OUTER BOOMS NEAR THE TRANSPORT RESTS. CARE MUST BE TAKEN TO
INSURE THE BOOMS REMAIN SECURE WHEN HYDRAULIC POWER IS NOT READILY
AVAILABLE.
To Next Page
Loading...
