Raising the Height of the Unit
This ice maker is ADA compliant, but by switching to the alternate feet provided, the default
height can be adjusted to 33 ½” and up to 34 ½”.
Tools needed: Phillips screwdriver
Changing the Feet
Using two or more people, lean the ice maker onto its back and unscrew the pre-installed leveling feet
and replace it with the high feet.
NOTE: If the nut on the feet are lower than the factory default height (2 ⅜”), the steel grill will not
fit.
Lower Grill Change
Unscrew the two bolts that fixing the lower grill, stacking the stainless grill on the plastic grill, install
them together.
Note: If the location nut on the feet are lower than the default height (2 ⅜”), the alternative lower
grill will not be fit.
To Next Page
Loading...
