PLACING AND INSTALLATION
CHOOSING THE RIGHT PLACE
To ensure that your beer dispenser works at the maximum efficiency it was designed for,
install it in a location where there is proper air circulation and electrical connections.
Choose a location where the beer dispenser will be away from heat and will not be
exposed to direct sunlight.
Models SBC-490-BIFR, SBC-490-BIFR-7(for commercial use), SBC-490BISSTB and
SBC-490BISSTB-7(for commercial use) are designed for indoor use only and should not
be used outdoors. Outdoor model SBC-490-OS and SBC-490-OS-TWIN are
U.L.approved for outdoor use.
CONNECTION TO POWER SUPPLY
Connect this appliance to a 3 prong power supply socket outlet (which has a ground
terminal). If you only have a two prong outlet have it replaced by a qualified
technician with an outlet that meets the local codes.
***DO NOT USE AN EXTENSION CORD***
Required nominal voltage and frequency are indicated on the rating plate. The
connection to the power supply and grounding has to be made according to current
standards and regulations.
The appliance resists temporary voltage tolerance from -15 to 10%.
On model SBC-
490-OS only, a GFCI (ground fault circuit interrupter) built into every line cord. In
the event the cooler is not operating, first check to see that the GFCI has not tripped, and
press the reset button.
6
To Next Page
Loading...
