To Next PageTo Next PageWhat to do if the 'NO SIGNAL' message appears on my Sun Microsystems Monitor?
If you see a 'NO SIGNAL' message or the power indicator is amber on your Sun Microsystems Monitor, ensure the video signal cable is properly connected and all plugs are firmly seated. Also, verify that the INPUT switch setting is correct and that the video input connector’s pins are not bent or pushed in.
General| Screen Size | 21 inches |
|---|---|
| Vertical Refresh Rate | 50 - 160 Hz |
| Aspect Ratio | 4:3 |
| Panel Type | CRT |
| Input Video Signal | Analog RGB |
| Dot Pitch | 0.26 mm |
| Viewable Size | 19.8 inches |
| Horizontal Refresh Rate | 30 - 95 kHz |
| Weight | 25 kg |
| Input Connectors | 15-pin D-sub |
Guidelines for power cord usage, installation locations, and general safety.
Procedures for cleaning, moving, and safely transporting the monitor.
Instructions for adjusting the monitor's viewing angle.
Description of buttons, switches, and lights on the front.
Identification of video input ports and their signal assignments.
Step-by-step guide for video cable connections.
Procedure for plugging in the monitor's power cord.
Turning on the system and resolving 'no picture' issues.
Guide to accessing and operating the monitor's menu.
Introduction to menus for contrast, size, geometry, convergence, screen, and color.
Accessing OPTION settings and resetting configurations.
Displaying signal frequency and resolution via the menu.
Procedure for modifying CONTRAST and BRIGHT settings.
Notes on CONTRAST/BRIGHT adjustments when sRGB is active.
Guide to EASY, PRESET, EXPERT, and sRGB color settings.
Securing settings, changing OSD language, and repositioning the menu.
Options to reset adjustments for current or all input signals.
Supported resolutions, frequencies, and power efficiency features.
Diagnosing thin lines and interpreting on-screen messages.
Displaying signal details and steps for 'CHANGE SIGNAL TIMING'.
Diagnosing and resolving issues related to the display not turning on or showing 'NO SIGNAL'.
Troubleshooting problems originating from connected computers or peripherals.
Resolving flickering, fuzzy images, and interference.
Step-by-step guides based on the power indicator status.
