Chapter 8 Upgrade of XSCF Firmware and Maintenance 8-13
c. If complete message, "Download successful: ..." and "MD5: ..." are displayed,
the XCP import has ended. Use the getflashimage(8) command with -l
option to confirm the imported version.
Note – After importing, if “Error: File is invalid or corrupt” message is displayed, it
means the XCP file that imported is not a correct file. There is a possibility of either
obtaining an illegal XCP file or that the XCP file was falsified by unauthorized access
after the customer downloaded the XCP file.
3. Perform the firmware update.
The XSCF firmware is downloaded and applied, and the OpenBoot PROM
firmware is downloaded.
a. Use the version(8) command to display the current firmware version.
b. Use the flashupdate(8) command to confirm whether to be able to update
the new firmware version. If the "XCP update is possible with domains up"
message is displayed, you can update the firmware
Note – If the XCP firmware version is 1050 or before, and if the “XCP update
enabled during system powered on state” message is displayed, you can update the
firmware.
XSCF> version -c xcp -v
XSCF#0 (Active)
XCP0 (Current): 1080
OpenBoot PROM : 02.07.0000
XSCF : 01.08.0001
XCP1 (Reserve): 1010
OpenBoot PROM : 02.07.0000
XSCF : 01.08.0001
OpenBoot PROM BACKUP
#0: 02.03.0000
#1: 02.07.0000
XSCF> flashupdate -c check -m xcp -s 1082
To Next Page
Loading...
Need help?
General
