Sunfire Atmos XTATM265 - Specifications

19
User's Manual
User's Manual
User's Manual
User's Manual
Specications
Amplier Output
1400 watts rms (3.3 Ω impedance)
High Cut Filter
30 Hz - 100 Hz adjustable, with a
"Bypass" position.
Frequency Response
30 Hz - 100 Hz
Power Line Voltage
US model
100-120 VAC 50/60 Hz
Fuse Rating 6A slow blow
International model
220-240 VAC 50/60 Hz
Fuse Rating 4A slow blow
Dimensions
Height 8.5 inches (21.6 cm)
Width 8.9 inches (22.6 cm)
Length 10.1 inches (25.7 cm)
Weight
32 lbs (14.5 kg)
Line Power Consumption:
330 watts average, at maximum continu-
ous output. 0.5 watts at idle.
1400 watts peak, time limited basis
Output Levels:
Greater than 106 dB peak SPL (includes
room gain) from 35 Hz to 80 Hz. Mea-
surement is one meter, anechoic.
A typical Sunre subwoofer can be
expected to beat its specied minimum
peak SPL by several decibels.
Total Harmonic Distortion
Typically less than 1/10 of the funda-
mental between 18 to 80 Hz.
Input Sensitivity (full output):
150 mVrms for full output with volume
control at maximum, 600 mVrms with
volume control at middle(0dB), no output
with volume control at minimum.
Input Impedance:
30 kΩ Line-Level Inputs
Driver: 6.5 inch
Extra large magnet and long throw
mechanical design yield very high
back-emf. The result is extraordinarily
high operating efciency – that is, more
acoustic output for each watt of input.
Internal System Gain:
50 dB from input jack to speaker with
volume control at 0 dB, 62 dB with con-
trol fully clockwise.
12 VDC Trigger Input
Input voltage range: 5 -18 VDC
Impedance: approx 600 Ω
(20 mA @ 12 V)
Removable terminal block.
© 2012 Sunre, a division of The AVC
Group LLC.
All rights reserved. Sunre reserves the
right to improve its products at any time.
Therefore, specications are subject to
change without notice.