Part # 4515558 (02/29/08) Page 9
OPERATION
Open Top Burners
Lighting:
1. Open 1/4 turn pilot isolation valves.
2. Light pilots.
3. Turn valve completely on. Burner ame should be 1/2
inch (13mm), stable blue ame, and should impinge on
the bottom of a pot placed on the ring grate.
Shut-Down:
1. Turn all valves to the “OFF” position.
2. If the unit is to be shut down for an extended period of
time, close the pilot isolation valves.
CAUTION: Should burner ignition fail within 5 seconds,
turn the burner valve o and repeat steps 1 through 5. If
ignition continues to fail, consult your factory authorized
service agency.
Standard Ovens
Lighting:
1. Remove oven bottom(s).
2. Depress and hold the red reset button, located on the
safety valve behind the kick panel below the oven door,
while lighting the oven pilot. Continue to hold the reset
button for at least 60 seconds after the pilot is lit. Release
the button. If the pilot does not stay lit, wait ve minutes,
then repeat the procedure.
Shut-Down:
1. Turn all valves and thermostats to the “OFF” position, or
lowest setting.
2. If the range is to be shut down for an extended period of
time, close the in-line gas valve.
Re-lighting:
1. Turn all gas valves o.
2. Wait ve minutes.
3. Follow procedure under “Lighting” at left.
To Next Page
Loading...
