SunFounder PiPower
Inside the network folder, create a new text file named my-network (without extension).
In the my-network file, write the following text, replacing MY_SSID and MY_WLAN_SECRET_KEY with your own net-
work’s SSID and password:
[connection]
id=my-network
uuid=72111c67-4a5d-4d5c-925e-f8ee26efb3c3
type=802-11-wireless
[802-11-wireless]
mode=infrastructure
ssid=MY_SSID
# Uncomment below if your SSID is not broadcasted
#hidden=true
[802-11-wireless-security]
auth-alg=open
key-mgmt=wpa-psk
psk=MY_WLAN_SECRET_KEY
[ipv4]
method=auto
[ipv6]
addr-gen-mode=stable-privacy
method=auto
Save and exit the file.
Step 10
Remove the microSD card from your computer and insert it into the Raspberry Pi. Then, connect the power (and
Ethernet cable if needed).
Go back to your computer and navigate to homeassistant.local:8123 , or if that doesn’t work, you can find the IP
address by checking your router.
During the first use of Home Assistant, you may need to wait for some time as it performs initial setup.
26 Chapter 4. Start to Play
To Next Page
Loading...
