SunFounder Pironman
7.5 5. Home Assistant MQTT Integration
Here, we will guide you through the essential steps required to set up MQTT (Message Queuing Telemetry Transport)
within your Home Assistant environment. MQTT is a crucial protocol often used for IoT devices and home automation.
By following these steps, you’ll seamlessly integrate MQTT into your Home Assistant system, allowing for efficient
communication and control.
Since MQTT operates within your local network, it’s not limited to running Home Assistant on the same Raspberry Pi
as the Pironman U1. If you have a separate Home Assistant server or Pironman U1 is running on a different system,
you can still configure Home Assistant to monitor Pironman U1.
1. Installing MQTT on Home Assistant
1. Click the button to navigate to the Mosquitto broker homepage.
2. Click to INSTALL the Mosquitto broker.
3. After installation, click START.
7.5. 5. Home Assistant MQTT Integration 89
To Next Page
Loading...