1
1
Web Login
1.1 System Description
1.1.1 Introduction
EMS300CP is a web-based local monitoring system. Addressing the problems of unused
surplus wind and PV power, unstable loads, and different electric prices between peak and
off-peak hours, it balances power supplies and demands economically and efficiently under
different application scenarios and operation modes by optimizing energy storage control
and distributed power output and coordinating the commissioning and ceasing of loads.
1.1.2 Requirements
Item Requirements
Browser Chrome 65 or above
Min. resolution 1920 x 1080
1.2 Login Steps
step 1 Connect the PC to the EMS300CP by using an Ethernet cable.
step 2 Configure the IP address of the PC and that of the Ethernet ports (ETH1, ETH2, ETH5) of
the EMS300CP to the same network segment. The IP address of the Ethernet ports are
shown below. The default address of ETH1 is 14.14. 14.14. And the IP address of the PC
can be set to 14.14.14. X where X cannot be 14, and the subnet mask can be set to
255.0.0.0.
table 1-1 Controller IP Address
Port Default IP address
ETH1 14.14.14.14
ETH2 12.12.12.12
ETH5 13.13.13.13
The above IP addresses are for reference only. The real IP addresses shall
prevail.
step 3 Enter the IP of the Ethernet ports in the address bar of the PC to enter the Web interface of
the EMS300CP.
step 4 Select the desired language in the upper right corner. Click Login and enter the login
password pw1111.
To Next Page
Loading...
