Need help?Do you have a question about the Sungrow SG60KTL and is the answer not in the manual?
General| Rated Output Power | 60 kW |
|---|---|
| Max. DC Power | 66 kW |
| Maximum DC Input Power | 66 kW |
| Input Voltage Range | 200 V - 1000 V |
| Start Voltage | 200 V |
| Number of MPPTs | 2 |
| Rated AC Power | 60 kW |
| Max. AC Power | 60 kW |
| Rated AC Voltage | 400 V |
| AC Output Frequency | 50 Hz / 60 Hz |
| THDi | < 3% |
| Max Efficiency | 98.7% |
| European Efficiency | 98.3% |
| DC Switch | Integrated |
| Protection Class | IP65 |
| Ingress Protection | IP65 |
| Topology | Transformerless |
| Power Factor | 0.8 leading to 0.8 lagging |
| Operating Temperature Range | -25 °C to +60 °C |
| Cooling Method | Natural Cooling |
| Humidity Range | 0 - 100% |
Covers pre-installation, electrical hazards, and cable integrity.
Warnings about operation, enclosure, arc flash, and PPE.
Safety precautions for maintenance, service, and component handling.
Data handling, configuration, communication, and protection features.
Factors for choosing an optimal installation location.
General procedure for mounting the inverter using a backplate.
Grid connection approval and AC breaker specifications.
Steps for grid connection and AC cable selection criteria.
Requirements for connecting multiple inverters.
Setup for PV input and guidelines for PV string design.
DC cable selection and connection procedures.
Explanation of grounding methods and secondary PE terminal.
Connecting single inverters and multiple inverters in a daisy chain.
Pre-commissioning checks for ambient environment.
Selecting country and grid code for proper parameter settings.
Step-by-step guide to start up and configure the inverter.
Procedure for safely disconnecting the inverter.
Solutions for issues indicated by LEDs and LCD fault codes.
Additional fault codes and their resolution steps.
Regular checks and cleaning for optimal performance.
Detailed steps for fan maintenance and replacement.
Cleaning procedures and contact information for support.
Interface for configuring running parameters.
Settings related to active and reactive power.
Configuring reactive power regulation modes.
Configuring ride-through protection and general protection parameters.
Configuring communication settings like Modbus and Uart.
To Next Page
