1
1 Safety Instructions
The inverter has been designed and tested strictly according to the international
safety regulations. As electrical and electronic equipment, safety instructions related
to them must be complied with during installation, commissioning, operation and
maintenance. Incorrect operation or work may result in damage to:
The life and well-being of the operator or a third party
The inverter and other properties that belong to the operator or a third party
Therefore, the following general safety instructions must be read and always kept in
mind prior to any work. All detailed work-related safety warnings and notes will be
specified at the critical points in corresponding chapter.
All installations should be performed by technical personnel. They have:
received professional training;
read through this manual and understood all related safety instructions;
been familiar with electric system related safety instructions.
Technical personnel mentioned above may perform the following work:
Install the inverter onto the wall;
Connect the inverter to the PV system;
Commission the inverter;
Operate and maintain the inverter.
Before Installation
There is a risk of injury due to improperly handling the device!
Always follow the instructions in the manual when moving and
positioning the inverter.
Injuries, serious wounds, or bruise may follow if the device is improperly
handled.
To Next Page
Loading...
Need help?
General
