Sungrow SH25T User Manual

122
Parameters SH8T SH10T
DC connection type
MC4 ( PV, Max.6mm² ) / Plug and play connector ( bat-
tery, Max.10mm² )
AC connection type Plug and play connector ( Max.16mm² )
Country of manufacture China
* Depending on the connected battery.
** Can be reached only if PV and battery power is sufficient.
*** Only when the DC switch is set to "ON", the DC Type II is able to provide effective protec-
tion against electrical surges.
Note:The output voltage of strings should all exceed the lower limit of the full load MPPT
voltage range. The difference in string voltage between different MPPTs should be less than
150V.
Parameters SH12T SH15T
Input (DC)
Recommended max. PV in-
put power
24000 Wp 30000 Wp
Max. PV input voltage
1000 V
Min. PV input voltage / Start-
up input voltage
150 V / 180 V
Rated PV input voltage
600 V
MPP voltage range
150 V - 950 V
MPP voltage range for rated
power
355 V - 850 V 335 V - 850 V
No. of independent MPP
trackers
2
3
No. of PV strings per MPPT
1 / 1
2 / 1 / 1
Max. PV input current 48 A (32 A / 16 A) 64 A (32 A / 16 A / 16 A)
Max. DC short-circuit current
60 A (40 A / 20 A) 80 A (40 A / 20 A / 20 A)
Max. current for input
connector
30 A
Battery Data
Battery type Li-ion battery
Battery voltage 100 V - 700 V
Max. charge / discharge
current
50 A */ 50 A *
Max. charge / discharge
power
15000 W / 12000 W 30000 W / 15000 W
Input and Output (AC)
Max. AC power from grid 43000 VA
11 Appendix User Manual

Sungrow SH25T Specifications

General

Brand	Sungrow
Model	SH25T
Category	Inverter
Language	English