SunHome Luminar 2 - Troubleshooting; Maintenance

20
10.0 Troubleshooting
The light bulb does not light.
Likely reason
Repair Method
The bulb is burned out.
Replace the bulb.
The bulb and the socket are not
connected well.
Pull the bulb out and check the socket. Replace the
socket if necessary.
The Control Panel is not operating.
Likely reason
Repair Method
The control panel cable is not
connected well.
Check the cable connection and fix it properly.
The fuse is burned out.
Replace the fuse located on the top of ceiling.
The indicator light power is on, but
no LED display
The control panel may need replacing.
The far-infrared heaters are out of order.
Observation
Likely reason
Repair Method
One of the
heaters does not
operate.
The heater is not connected properly.
Check the connection.
The heater needs replacement.
Replace the heater.
None of the
heaters operate.
The power plug is not connected properly
Check the power plug.
The heaters are not properly connected
Fix the connections.
The relay has malfunctioned.
Replace the relay.
The control panel has malfunctioned.
Replace the control
panel.
11.0 Maintenance
Before using your sauna for the first time, clean the inside of the sauna with a damp
cloth.
Use your favorite furniture polish on the exterior.
Place a towel on the bench to absorb any perspiration. Wash these often to maintain a
clean and pleasant environment inside your sauna.
Perspiration may darken the wood over time. This can be removed by a light sanding
with fine grit sandpaper.
The sauna room should be kept clean and odor free.