15
WARM UP TIME AND USAGE GUIDELINES
The controls are preset to 60 minutes at 150°F. However, the inside cabin
temperature is not intended to reach this. Our saunas are based on the infrared
wavelength and not cabin temperature. Allow the sauna to warm up for 30-45
minutes. The sauna heats up at an average of 1 degree per minute. Follow
these steps for proper warm up:
Step 1: Make sure your sauna is plugged into a dedicated outlet installed by
your electrician.
Step 2: Check the settings on the keypad. The default setting should be set to
150 degrees and the timer set to 60 minutes.
Step 3: When turning sauna on for the first time, ensure each heater is warming
up after a couple of minutes. If they are not, make sure connections are securely
connected.
NOTE: If your sauna is outside or in an unheated garage, sun room, basement or
patio, you may require additional time to warm the sauna up depending upon the
temperature of the surrounding surface & room. Keep in mind you are required to
have an authorized Sunlighten cover over your sauna if it is outside or exposed to the
weather in order to maintain your warranty.
RESERVATION MODE
1. Turn off the sauna
2. Press the timer up and timer down arrows simultaneously
3. A digit will appear on the timer section of the screen to indicate the number of
hours before the sauna turns on.
4. When the timer counts down to “0,” the sauna will turn on for a 60 minute
session and will be set to 150 degrees.
To cancel a reservation, press and hold the power button until the time display
turns off. At this point you can turn the sauna on normally.
To Next Page
Loading...
Need help?
General
