Need help?Do you have a question about the Sunlux XL-626A and is the answer not in the manual?
Configure scanner programming mode.
Restore scanner to factory settings.
Define scanner behavior for decoding attempts.
Configure the number of times to decode a barcode.
Enable/disable all symbologies or restore defaults.
Enable/disable specific barcode types.
Configure check digit validation for symbologies.
Configure add-on codes for EAN/UPC barcodes.
General| Light Source | 650nm visible laser diode |
|---|---|
| Scan Rate | 100 scans per second |
| Operating Temperature | 0°C to 50°C |
| Type | Laser |
| Interface | USB, RS-232, PS/2 |
| Supported Barcodes | UPC-A, UPC-E, EAN-8, EAN-13, Code 39, Code 128, Interleaved 2 of 5, Codabar |
| Storage Temperature | -20°C to 60°C |
| Humidity | 5% to 95% (non-condensing) |
To Next Page
