16
SolutionProblem
roubleshooting
T
1. Check source of ac power. Reset circuit breaker
or replace fuse if necessary.
2. Make sure the unit is plugged into outlet.
3. Make sure cord between canopy and bench is
properly connected.
4. Make sure timer dial is turned to a number past 0.
1. Check that lamp is installed correctly.
2. Switch unlit lamp with a lamp that lights. If the
new lamp lights and the old lamp still does not,
replace old lamp.
3. If replacing lamp does not remedy problem, con-
tact your service representative.
1. Replace gas springs when they no longer have suf-
ficient power to aid in lifting the canopy.
1. Check source of ac power. Reset circuit breaker
or replace fuse if necessary.
2. Check timer system per maintenance instructions
in this guide. Contact your local service
representative.
Lamps fail to light
One or more lamps fail
to light
Canopy fails to stay in the
up or down position
Sunbed does not stay lit
Problem/Solution Chart
To Next Page
Loading...
