3
Pre-Installation Planning
Before you begin to assemble your sunbed, you should observe the following pre-
installation considerations.
Installation-Pre-Installation Planning
• Your sunbed operates from a 120V ac source. You should have a NEMA
5-20R electrical outlet (like the type shown below) installed in the room
in which you will use the unit. The outlet should be on a dedicated cir-
cuit capable of providing 20 Amp service. (We recommend installation by
a professional electrician.) The outlet must be earth grounded.
20 AMP NEMA #5-20R RECEPTACLE
• Make sure the room in which you intend to use your sunbed is well
ventilated. Air from the room is used to cool the sunbed, and a poorly
ventilated room may cause the unit to become hot and cause discomfort
to the user.
• Your sunbed is designed to operate in an ambient room temperature of
80°F maximum and 70% relative humidity.
• Place your sunbed no closer than 6" from any wall. Make sure that cur-
tains, drapes, and other room furniture do not obstruct the airflow into
the end caps or out of the fan opening areas.
• Proper assembly of your sunbed requires three people. Plan to have a
couple of helpers assist you.
To Next Page
Loading...
