No. 7, Road 12, Industrial Zone, Taichung City 407, Taiwan
Tel: 886-4-2359-1190 sales@sunriseiw.com.tw
Fax: 886-4-2359-3409
www.sunriseiw.com.tw
- 2 -
SAFETY PRECAUTIONS
IMPORTANT:
It is the duty of both employer and employees to acquaint themselves
with the safe working practices contained in this manual and ensure
that all operators adopt these practices.
While every effort has been made to furnish sufficient safe guards, this
equipment, if not operated and maintained properly, has the potential to
cause serious injury or death. A thorough knowledge of the machine and
operating with carefulness is the best protection against accidents.
All operations are controlled by either the foot switch or by the optional
electric backgauge. The operator should be familiar with the control and
function of the switch/backgauge before perform the operation.
Many warning labels are fixed on the machine. NEVER REMOVE THESE
LABELS. Be sure to follow these warnings to avoid injury.
Please also pay attention to the following general rules:
1.
Do not operate the machine unless all safety guards and hold-downs are
in place. Use of optional attachments/tooling should also have proper
hold-downs and guards installed. If any guards are damaged or worn
out, replace immediately with new guards.
2.
On the single cylinder models, only one operator is allowed to operate
the machine. Before each operation, make sure no other person is near
the machine.
3.
Operator must wear Protective Glasses during operation to protect
the eyes.
4. Keep hands clear of all moving parts at all times. Fingers must not
go under or inside the danger zone established by the safety guards,
stripper, and/or holddowns.
5.
On IW-50A and IW-60H which has a notcher, the nature of the station
To Next Page
Loading...
