8
andin
a. Using your Awning, measure the distance
from the right end of the Square Bar to the
inner and outer edges of the right Arm Clamp
and record those measurements.
b.
Clamp.
c.
andin
or a door, use these steps to locate the studs inside
your home and transfer those measurements to the
outside. Get a roll of duct tape or similar tape. From
inside your home on the wall that your Awning will
the tape or door to the center of the stud, and write
On the outside wall, using the inside measurements,
line.
it easier to insert the pre-assembled Awning into the
wide Awnings, install
a
See on .
wide Awnings, install
a
See on .
.
- Between the two Arms,
.
- On the nearest stud about 2’ from the
- On the nearest stud about 2’ from the
middle point of the Awning, toward the right.
- Between the two Arms,
.
- Between the right end of the Awning
and the right Arm,
.
To Next Page
Loading...