SunStar KM-2300 - 7-2. Supplying grease (KM-2300 S & F)

26
7-2. Supplying grease (KM-2300S 󳣑 & F 󳣑 )
7-2-1. Supply grease
1. Only use the Sunstar’s genuine grease enclosed in the
accessory box. (Serial number : GP-001992)
2. Make a hole on the frontal tip of the grease tube by using the
cap ② of the tube.
3. Attach the enclosed grease feeder firmly to the tube. (Serial
number : GP-001994)
4. Apply the grease to the place where the grease needs to be
applied.
5. If the grease is used up, only buy and use the Sunstar’s
genuine grease.
[ Figure 38 ]
①
②
③
(GP-001994)
(GP-001992)
7-2-3. How to supply grease
1. Turn off the power.
2. Remove the screw.
3. Supply grease until grease goto over arrow mark.
4. Fasten the screws.
5. Turn polley 5~10 times by hand.
6. Wipe flowed grease.
7. Turn on the power and start sewing.
7-2-2. Greaging cycle
1. Supply grease every six month after set up the macine.
[ Figure 39 ]
screw
screw
screw
screw
KM-2300 S󳣑 & F󳣑 KM-2300 F󳣑
screw