118
Tape Reader and Communication
NO. CORRECTIONMEANINGERROR MESSAGE
Data read error
Network system not found.
Error on the data read through
the tape reader.
Network device is not connected.
Enter data through tape reader
again.
Check the connection of the
network device.
630
640
Memory
NO. CORRECTIONMEANINGERROR MESSAGE
Memory file not found.
Insufficient system memory.
Insufficient memory.
Memory system error.
Memory backup system error.
Embroidery data is not in
memory.
Not enough memory for data.
Memory is full to capacity.
Error while copying or deleting
data.
Battery is worn out.
Save the embroidery data on a
floppy or tape.
Delete unnecessary data.
Delete unnecessary data.
Reset or turn the main switch
off and then on again.
Contact the nearest A/S center
and replace the battery.
700
701
702
703
704
System Installation
NO. CORRECTIONMEANINGERROR MESSAGE
System file not found. System is not installed. Install the system with the
installation disk.
800
To Next Page
Loading...
Need help?
General
